Quick summary: Espressif released Arduino-ESP32 3.3.13 on 17 November 2026. The stable core adds custom Matter endpoints and new board definitions, while fixing I²C slave operation on newer chips, several BLE and OTA faults, and a broad set of networking edge cases.

Matter becomes more flexible
The headline addition is an API for creating custom Matter endpoints. That gives Arduino developers more freedom to describe devices that do not fit the core’s existing endpoint helpers. The release also improves Matter helper functions, adds an identity field and supplies 4MB and 8MB Matter partition schemes.
Those are software capabilities, not a blanket promise that every ESP32 board can run a particular Matter project. The selected chip still needs the appropriate radio and SDK support, while the development board must provide enough flash for the chosen partition layout. The application also has to define and implement the endpoint correctly. Updating the core does not add Thread, extra flash or exposed pins to hardware that lacks them.
I²C, BLE and OTA fixes
For peripheral-heavy builds, 3.3.13 fixes Arduino Wire slave mode on newer ESP32-family SoCs. BLE changes allow repeated UUIDs to be registered and treat an “already complete” response during an MTU exchange as success, reducing failures in applications that reconnect or build more complex GATT layouts.
Over-the-air update code gains an onPrepare() callback, and a stalled update stream now times out after 30 seconds rather than counting 300 reads. The command-line espota tool can prompt when an OTA password was not supplied. These changes should make update workflows easier to control, but production firmware should still be tested with its actual bootloader, partition table and rollback policy.
Networking gets the largest clean-up
Espressif has fixed several cases that could cause unreliable or surprising network behaviour. WiFiMulti::addAP() now accepts the full 32-byte SSID length, IPv6 DNS configuration is supported, and DNS question parsing is bounded to the received UDP packet. The core also stops a connection attempt when name resolution fails and avoids an LwIP task lock when an AsyncUDP receive queue fills.
WebServer changes repair authentication with multiple clients, validate headers more strictly and count the actual bytes in a POST body. HTTPClient now times out if a server stops sending a response body, while stream uploads count bytes actually read. These are defensive reliability improvements; Espressif’s release notes do not assign CVE identifiers or severity ratings to them.
More boards, without changing their hardware
New or revised board definitions cover the Soldered NULA CAN ESP32-S3, LilyGo T-Deck, YB ESP32-S3 RS485, Kode Dot ESP32-P4Price, ELEGOO ESP32-C6, mannaNAUTA ESP32-S3 and DFRobot FireBeetle 2 ESP32-C5PriceAliExpress price. Support also lands for both SparkFun ESP32-P4 IoT RedBoards. A board definition selects pins, flash layout and build settings; it does not imply that every peripheral in the underlying chip is wired out on the board.
The core is based on ESP-IDF 5.5.6+, so it should not be confused with the separate ESP-IDF 6.1.1 release from the same week. Other additions include multi-sample-rate USB Audio support for UAC1 and UAC2, an HMAC builder and a configurable cipher list for NetworkClientSecure.
Availability and upgrade advice
Arduino-ESP32 3.3.13 is available now through Espressif’s stable Boards Manager package. Existing projects can select the version in Arduino IDE’s Boards Manager. Reproducible builds should pin the core version, and developers using Matter, BLE, OTA, WebServer or custom partitions should run regression tests before updating deployed devices.
